GN Netcom 501 SC Guide De L'utilisateur page 4

GN501-3_SC_NA 09/11/04 23:12 Side 2
2. Setting up
To set up your GN 501 SC/GN 503 SC, complete the following:
Plug the speaker connector (orange) into the speaker port of your computer.
Plug the microphone connector (pink) into the microphone port.
Adjust the headset's boom so that it is pointed in the direction of your mouth.
3. Features and customization
Volume control
The in-line volume control lets you quickly adjust the volume from the speaker.
Mute functionality
The in-line mute functionality switches the transmission of your voice on/off.
4. Frequently asked questions
Why is there no sound output from the headset?
Increase the volume using the in-line volume control.
Adjust the audio source's volume control (computer/soundcard/application control panel),
or adjust the output level on other audio playback devices.
Verify that the headset and all connectors are properly plugged into the correct ports.
Why is there no sound input from the microphone?
Ensure that the microphone isn't in mute mode (the mute switch must be off).
Adjust the microphone volume settings of the target audio device (computer/soundcard/-
application control panel), or adjust the input level on other audio recording devices.
Verify that the headset and all connectors are properly plugged into the correct ports.
Cleaning, safety and maintenance
Clean the headset, including the headset boom arm, by wiping with a slightly damp cloth as
required. Dampen the cloth with only water and a little washing-up liquid if needed. Avoid
getting moisture into any button sockets or other openings.
2