Ruwido digital 2 Manuel D'utilisation page 18

GB
Automatic TV search
As an alternative, or if neither manual programming nor automatic programming by
brand has found the correct code for your TV set, you can use the automatic search
function.
1) Switch your TV set on.
2) Press and hold the TV Standby button (
If the button is not pushed long enough, the TV set switches off. In this case, start
the programming again by switching the TV set on.
3) Use the number buttons to enter the code
twice to confi rm that the search process has been activated.
4) Hold down the Standby button ( ) on your digital_2 until the TV set switches off.
This process can take several minutes.
5) As soon as the unit has switched off, push the OK button to confi rm the
programming (
6) Test the functionality of your remote control using the TV standby button (
the AV button (
correctly programmed and can be used.
Note
several codes to which your TV set responds, but where all buttons do not function
for each code. In this case, the search process should be re-started (steps 2 to 6)
until you obtain the best code. Re-starting the search process starts at the last
saved programming.
Automatic search process on the satellite receiver and the DVB-T
(Freeview)/cable-box (STB)
As an alternative, or if neither manual programming nor automatic programming by
brand has found the correct code for your unit, you can use the automatic search
function.
1) Switch your TV set, satellite receiver or DVB-T (Freeview)/cable-box (STB) on.
2) Press and hold the STB Standby button (
twice.
3) Use the number buttons to enter the code
twice to confi rm that the search process has been activated.
4) Hold down the STB Standby button (
off. This process can take several minutes.
5) As soon as the unit has switched off, push the OK button to confi rm the
programming (
6) Now test the individual buttons on your remote control for function, starting with the
STB Standby button (
buttons 1 to 21 (in accordance with functional description table). The AV button (
and TV Standby button (
7) If the unit responds properly to all functions, your digital_2 is correctly programmed
and can be used.
Note
several codes to which your unit responds, but where all buttons do not function for
each code. In this case, the search process should be re-started (steps 2 to 7) until
you obtain the best code. Re-starting the search process starts at the last saved
programming.
BA digital_2 RC10120 Innenteil, V1, 105x210 mm, 1c CS4.indd 18 BA digital_2 RC10120 Innenteil, V1, 105x210 mm, 1c CS4.indd 18
OPERATING INSTRUCTIONS
ruwido digital_2 universal remote control
) until the Signal LED ( ) fl ashes twice.
ok
). If the TV set responds properly to all functions, your digital_2 is
av
: It could happen, that during the search process, the digital_2 fi nds
) until the Signal LED ( ) fl ashes twice.
ok
), volume buttons (volume
stb
) are not tested.
tv
: It could happen, that during the search process, the digital_2 fi nds
) until the signal LED ( ) fl ashes twice.
tv
. The Signal LED ( ) fl ashes
1 0 0 1
) until the signal LED ( ) fl ashes
stb
. The Signal LED ( ) fl ashes
3 0 0 1
) on your digital_2 until the unit switches
stb
/ ), and then with the
18
) and
tv
)
av
19.01.2011 12:29:44 19.01.2011 12:29:44