VOLTCRAFT 12 50 52 Mode D'emploi page 32

Press button to switch to the area for setting the standby power.
c) Setting the standby power
1. Press SET button once. The power value starts flashing (fig. 20 + 21).
2. This function is used to set the standby power value, which is useful for the total energy
calculation. Use
separately. The setting range is 0.001 - 9.999W.
3. After setting the normal standby power the display will switch to the area for setting the
low-energy standby power. The display will show
(fig. 22).
4. Perform the setting following the same procedure as for normal standby power and press SET to
confirm your setting. The setting range is 0.001 - 9.999W.
W
fig. 20
Press button to switch to the area for setting the GHG/CO
d) Setting the rate of GHG/CO
1. Press SET button once. The "GHG" (greenhouse gas) / "CO
2. Use or buttons to set the value and press SET to confirm. Set each digit separately.
fig. 23
Press button to switch to the area for setting the OVERLOAD limit.
32
buttons to set the value and press SET to confirm. Set each digit
or
W
fig. 21
2
fig. 24
indicating the low-energy standby power
W
fig. 22
alarm limit.
2
" value starts flashing (fig. 24).
2