Setting Of The Desired Temperature; Comparison Of Actual/Desired Temperatures; Automatic Sauna Control Switch-Off; Safety Switch-Off - ABATEC WAVE 1 Mode D'emploi

2.4.0 SETTING OF THE
DESIRED TEMPERATURE
Set the desired temperature by turning the
upper thumbwheel.
2.5.0 COMPARISON OF
ACTUAL/DESIRED
TEMPERATURES
The desired temperature selected via the
thumbwheel is shown on the display as
follows:
green light: low temperature
orange light: medium temperature
red light: high temperature
The same colour system is used to show the
temperature values measured inside the
sauna cabin on the actual temperature
display.
When the colours on both displays are
identical, the desired temperature
corresponds to the actual temperature.
WE DO IT FIRST.
INSTRUCTION MANUAL
BEDIENUNGSANLEITUNG
DESIRED VALUE EXCEEDS
ACTUAL VALUE
DESIRED VALUE CORRESPONDS
TO ACTUAL VALUE
2.6.0
For safety reasons, the sauna control unit is
switched off automatically after 6 hours.
2.7.0
The control unit is equipped with a safety
switch-off function, based on a thermal safety
release. This thermal safety release is installed
inside the sensor housing, which is mounted
above the sauna heater. If, having reached the
desired temperature, the sauna heater should
not stop heating due to any defect, the thermal
safety release interrupts the circuit
automatically at a temperature of 139 ° C and
switches off the sauna heater. Should such a
switch-off take place, the sensor PCB must be
exchanged and a specialist must be consulted.
AUTOMATIC SAUNA
CONTROL SWITCH-OFF

SAFETY SWITCH-OFF

20/42