First Use - Zanussi ZBF11421SA Notice D'utilisation

QuickFreeze light
3
QuickFreeze switch and alarm reset switch
4
Switching on
Connect the appliance to the main power
supply.
1. Turn the Temperature regulator clockwise
to a medium setting.
The power indicator light will light up and a
sound will signal for 2 seconds.
If the temperature inside the
appliance is too high, the Alarm light
will blink and the sound signal alarm
will turn on.
2. Push the QuickFreeze switch and the
sound signal alarm will get off.
3. Push the QuickFreeze switch once again
and the QuickFreeze light will light up. The
appliance will start to operate.
Switching off
Turn the Temperature regulator to the "O"
position and a sound is on only for 2 seconds .
The power indicator light will switch off.
Temperature regulation
The temperature is regulated automatically.
A medium setting is generally the
most suitable.
However, the exact setting should
be chosen keeping in mind that the
temperature inside the appliance
depends on:
• room temperature,
• how often the door is opened,
• the quantity of food stored,
• the location of the appliance.
1. Turn the Temperature regulator toward
lower settings to obtain the minimum
coldness.
2. Turn the Temperature regulator toward
higher settings to obtain the maximum
coldness.

First use

Cleaning the interior
Before using the appliance for the first time, the
interior and all internal accessories should be
16
Alarm light
5
CAUTION!
If the ambient temperature is high or
the appliance is fully loaded, and the
appliance is set to the lowest
temperatures, it may run
continuously causing frost to form
on the rear wall. In this case the dial
must be set to a higher temperature
to allow automatic defrosting and
therefore reduced energy
consumption.
QuickFreeze function
Press the QuickFreeze button.
The QuickFreeze indicator appears.
To switch off the function before its automatic
end, press the QuickFreeze button until the
QuickFreeze indicator turns off
High temperature alarm
If the temperature inside the freezer has risen to
a point where the safe storage of frozen food is
no longer ensured (for example due to an power
failure), the Alarm light will blink and an acoustic
alarm will sound.
When the freezer is first switched
on, the Alarm light blinks until the
temperature has dropped to a safe
level for the storage of frozen food.
1. Switch off the warning tone by pressing the
QuickFreeze switch.
The QuickFreeze indicator appears.
The Alarm light blinks until the required
temperature has been reached again.
2. Release theQuickFreeze switch as soon as
the Alarm light is off.
The QuickFreeze indicator turns off.
washed with lukewarm water and some neutral
soap to remove the typical smell of a brand-new
product, then dried thoroughly.
www.zanussi.com