Pride Mobility TRAVEL SCOOTER Série Mode D'emploi page 9

Manual Freewheel Lever
Whenever you need or want to push your Travel Scooter for short distances, you can put it in freewheel mode.
1. Locate the manual freewheel lever at the top right of the rear section.
2. Push forward on the manual freewheel lever to disable the drive system and the brake system. You may now
push your Travel Scooter.
3. Push the manual freewheel lever rearward to reengage the drive and the brake systems; this takes your Travel
Scooter out of freewheel mode.
WARNING! When your Travel Scooter is in freewheel mode, the braking system is disengaged.
Disengage the drive motors only on a level surface.

Ensure the key is removed from the key switch.

Stand to the side of the scooter to engage or disengage freewheel mode. Never sit on a

scooter to do this.
After you have fi nished pushing your Travel Scooter, always return it to the drive mode to

lock the brakes.
Motor/Transaxle Assembly
The motor/transaxle assembly is an electromechanical unit that converts electrical energy from your Travel
Scooter's batteries into the controlled mechanical energy that drives the Travel Scooter's wheels.
Anti-Tip Wheels
The anti-tip wheels are an integral and important safety feature of your Travel Scooter. They are bolted to the
frame at the rear of the Travel Scooter.
PROHIBITED! Do not remove the anti-tip wheels or modify your Travel Scooter in any way that is
not authorized by your Provider.
WARNING! The anti-tip wheels may cause interference with the smooth transition of your Travel
Scooter when ascending or descending a curb. Contact your authorized Provider for more
information.
Main Circuit Breaker (Reset Button)
When the voltage in your Travel Scooter's batteries becomes low or the Travel Scooter is heavily strained because
of excessive loads or steep inclines, the main circuit breaker may trip to protect the motor and electronics from
damage. See fi gure 6.
 The main circuit breaker reset button pops out when the breaker trips.
 When the breaker trips, the entire electrical system of your Travel Scooter shuts down.
 Allow a minute or two for your Travel Scooter's electronics to "rest."
 Push in the reset button to reset the main circuit breaker.
 If the main circuit breaker trips frequently, you may need to charge your batteries more often. You may also
need to have your authorized Provider perform a load test on your Travel Scooter's batteries.
 If the main circuit breaker trips repeatedly, see your authorized Provider for service.
Travel Scooter Series
I I . Y O U R T R A V E L S C O O T E R
9