Pride Mobility TRAVEL SCOOTER Série Mode D'emploi page 11

Manual Freewheel Lever
The 3-pin end of the charger power cord plugs into this
receptacle. See fi gures 7 and 8.
Tiller Console Fuse (If Equipped)
The fuse located under the battery pack protects the
tiller console electronics. See fi gure 6. In the event
any component of the tiller console is not responding,
check this fuse. See VII. "Basic Troubleshooting" for
fuse replacement instructions.
Off-Board Battery Charger
The off-board battery charger, when plugged into the
charger power cord receptacle and a standard electrical
outlet, charges the Travel Scooter's batteries. See
fi gure 9.
SECUREMENT POINTS
Always secure the Travel Scooter in a forward-facing
position in the vehicle. Attach the four tie-down straps
to the designated securement points. See fi gure 10.
Tighten the straps to suffi ciently remove all slack.
Never attach tie-downs to adjustable, moving, or
removable parts of the Travel Scooter such as armrests,
shrouds, and wheels. These items should be removed.
Position the anchor points for the rear tie-down
straps directly behind the rear securement points on
the Travel Scooter. The front tie-down straps should
anchor to fl oor points that are spaced wider than the
Travel Scooter to provide increased lateral stability.
WARNING! Ensure Travel Scooters are
properly secured to the motor vehicle
during transport. Scooters that are
not properly secured can become a
hazard to the user and to other vehicle
passengers in the event of a crash,
sudden stopping, or swerving, as the
Travel Scooter could tip or slide out
of place.
Travel Scooter Series
I I . Y O U R T R A V E L S C O O T E R
Figure 7. Charger Power Cord Receptacle (Tiller Mounted)
XLR
Figure 9. Off-board Battery Charger
11