Operation - Renkforce CW-40 Mode D'emploi

b) Operation
The device can be operated in three different manners:
Operation right at the device
For this operating mode, the DIP switch 10 must be in the ON position and the green LED below
the DIP switches (1) must be lit.
• Set the fog emission amount with the DIP switches 1-4.
DIP switch Fog emission
1 = ON 25 %
2 = ON 50 %
3 = ON 75 %
4 = ON 100 %
• Set the fan speed with the DIP switches 6-9.
DIP switch Fan speed
6 = ON 25 %
7 = ON 50 %
8 = ON 75 %
9 = ON 100 %
Operation with the wire-bound remote control
For this operating mode, the DIP switch 10 must be in the OFF position and the green LED below
the DIP switches (1) must flash.
In this mode, the device cannot be operated right at the device.
The green LED at the remote control will light up once the device is heated and ready.
MANUAL
• Press the green MANUAL (12) button on the remote control.
• The device emits fog as long as you keep this button pressed.
• The fog emission is always 100 %.
The MANUAL operating mode always takes precedence over the operating modes CONT and
TIMER. If the green button MANUAL (12) is pushed, the fog emission always is 100 %.
28