Operation - Renkforce A-2001 Mode D'emploi

All manuals and user guides at all-guides.com
c) Operation
Always pull the mains plug before filling the fog machine.
Never fill the fog machine with flammable liquids or add such to the fog liquid. Only ever use
suitable water-based fog liquids (the CONRAD range features suitable fog liquids, see „Techni-
cal Data").
Never tilt the fog machine. Fog liquid may leak out or enter the inside of the device and cause
damage there or injure the operator.
Make sure that no liquid enters the inside of the device when you are filling it with fog liquid.
This may cause damage to the device and potentially fatal electrical shock.
• Ensure that the mains plug is not plugged in.
• Unscrew the tank cover from the device and fill fog liquid into the tank.
• Then screw on the tank closure lid again.
• Plug the connection plug of the remote control into the REMOTE CONTROLLER ONLY (5) port on the rear
of the fog machine.
• Plug the mains plug into a mains socket with a protective ground contact.
• Turn on the device with the POWER mains switch (2). With the device on, the mains switch lights up and
the fog machine heats up.
• Heating up takes approx. 2.5 minutes.
• Once the device has reached its operating temperature, the green indicator LED on the remote control is
lit and the device is ready for operation.
Manual Operation:
• Press the green MANUAL (11) button on the remote control.
• The device emits fog as long as you keep this button pressed.
Continuous operation:
• Press the red CONT (10) button on the remote control.
• The device emits fog permanently and the red indicator LED is lit.
• Set the desired fog quantity using the VOLUME (12) controller.
• To deactivate permanent operation, push the red CONT (10) button on the remote control again.
24