Publicité
No light indicator.
No co ee, no water.
Co ee comes out very slowly.
Co ee is not hot enough.
Capsule area is leaking
(water in capsule container).
Irregular blinking.
No co ee, just water runs out (despite inserted capsule).
Aeroccino does not start.
Quality of milk froth not up to standard.
Red Button blinking.
Milk Over ows.
Check the mains, plug, voltage, and fuse. In case of problems, call the Nespresso Club.
First use: ll water tank with warm water (max. 55° C) and run through machine according to instructions on
page 10.
Fill water tank.
Descale
Flow speed depends on the co ee variety.
Descale
Preheat cup.
Descale if necessary.
Position capsule correctly. If leakages occur, call the Nespresso Club.
Send the appliance for repair - Contact the Nespresso Club.
In case of problems, call the Nespresso Club.
Be sure to position the jug correctly on a clean base. Be sure to attach the whisk to the jug
Be sure to use whole or semi-skimmed milk at refrigerated temperature (about 4-6° C). Be sure to use the
appropriate whisk and ensure the jug is clean.
a) The appliance is too hot. Rinse it under cool water b)
up to one of the two «max» level.
Be sure to use the appropriate whisk and check the corresponding indicator level.
correctly.
c) Not enough milk. Fill milk frother
EN
19
Publicité
Chapitres
