Publicité
Les langues disponibles
Les langues disponibles
Operating instructions
EN
CHAPTER 1
GENERAL
INFORMATION
m
ATTENTION
CHAPTER 2
TECHNICAL DATA
Controller AIR1-BE ECO
1.0 Important information
In order to ensure correct operation and for your own safety, please read and observe the
following instructions carefully before proceeding. Relevant national standards, safety regula-
tions and provisions (e.g. DIN EN VDE 0100) as well as the technical connection conditions of
the energy supply company must be observed and applied.
Keep the operating instructions close to the unit for easy reference. After the final assembly,
the document must be issued to the operator (tenant/owner).
1.1 Warning and safety instructions
The adjacent symbol is a safety-relevant prominent warning label. All safety regulations and/or
symbols must be absolutely adhered to, so that any dangerous situation is avoided.
1.2 Warranty claims – Exclusion of liability
Our warranty shall not apply if the following instructions are not observed. The same applies
for liability claims against the manufacturer. The use of accessories, which are not recom-
mended or offered by Helios, is not permitted. Any damage that may occur is not liable for
warranty.
1.3 Regulations – Guidelines
If the product is installed correctly and used to its intended purpose, it conforms to all appli-
cable regulations and CE guidelines at its date of manufacture.
1.4 Receipt
Please check delivery immediately on receipt for accuracy and damage. If damaged, please
notify the carrier immediately. In case of delayed notification, any possible claim may be void.
1.5 Storage
When storing for a prolonged time the following steps are to be taken to avoid damaging
influences:
Protection by dry, air- dustproof packing (plastic bags with drying agent and moisture indica-
tors). The storage place must be water proof, vibration-free and free of temperature variations.
Damages due to improper transportation, storage or commissioning are verifiable and not
liable for warranty.
1.6 Area of application – Intended use
The controller AIR1-BE ECO is designed for commissioning and controlling AIR1 compact
units. All AIR1 compact units available in the Helios range can be controlled with the controller.
Any use other than the intended use is prohibited!
2.0 Technical data
AIR1-BE ECO
Operating voltage
Power
Protection category
Dim. mm
Operating temperature
Storage temperature
Ambient humidity
1 1
24 V DC
0,24 W
IP30
W 115 x H 95 x D 25
5 to 40 °C
-40 to 50 °C
5 to 95 % RH
Publicité
