Use - MAAX Z 07134 Mode D'emploi

7. Fill the kettle with tap water up to the Max mark and boil it (see chapter
"Use"). Then pour the water out. Repeat this process twice.
8. The kettle is now ready for use!

Use

ATTENTION!
• Scalding hazard! Caution: Risk of emitted steam! Be careful when pouring out
hot water.
• When the device is in use or shortly afterwards, avoid any contact with the
metal surface of the device. It becomes very hot!
• Do not fi ll water past the Max mark. Otherwise, the water may spray out of
the spout while it is being boiled.
• Make sure that the switch is not obstructed and that the lid is closed fi rmly.
The kettle will not switch off if the switch is obstructed or if the lid is left open.
1. If you have not already done so, place the base on a dry, level, solid, and
heat-resistant surface and insert the mains plug in a properly installed so-
cket.
2. Take the kettle off the base. Open it by pushing the button on the handle and
fi ll the kettle with tap water. Make sure that the water volume is between the
Min and Max mark. If there is not enough water in the kettle, the device will
deactivate before completing the boiling process; if it is fi lled past the Max
mark, water may spray out during the boiling process.
3. Close the lid and place the kettle back on the base.
4. Push the On/Off switch on the kettle down. The device will turn on and the
control light will illuminate. The fl ower decoration will change colour as the tem-
perature rises and the colour will persist after the boiling process as long as the
kettle has not yet cooled off.
You can interrupt the boiling process at any time by pushing the On/Off
switch up.
5. The kettle automatically deactivates once the water has boiled. The On/Off
switch will fl ip up.
6. Take the kettle off of the base and carefully pour the water into a suitable
container.
Let the device cool off before you add more cold water and boil it.
If not in use, the kettle may be stored on the base. However, be sure to pull the
mains plug out of the socket.
If you inadvertently operate the kettle without water, the device will
automatically switch off. Let the kettle cool off before you use it again.
17 GB