Pattfield Ergo Tools PE-EHH 9048 Traduction De La Notice Originale page 200

the mounting clip back to the closed position and secure with the fas-
tening screw.
Mounting the extension pole and cutter bar (Fig. 4a – 4c)
Depending on the height you need to reach, you can use the hedge
trimmer with or without the extension pole (Fig. 2/Item 9). To use it,
loosen the fastening screw (Fig. 4a/Item C) on the motor unit. Re-
move the protective cap (Fig. 2/Item 14) from the extension pole
and insert the extension pole into the clamp on the motor unit. When
inserting the extension pole, ensure that the snap button latches
in the hole in the clamp (Fig. 4b/Item D). Then fasten the extension
pole using the fastening screw. To mount the cutter bar, loosen the
fastening screw (Fig. 4c/Item C). Remove the protective cap (Fig. 2/
Item 14) from the cutter bar unit and insert the cutter bar unit into the
clamp on the extension pole. Once again, ensure that the snap but-
ton latches in the hole in the clamp (Fig. 4b/Item D). Then fasten the
cutter bar using the fastening screw.
Adjusting the tilt angle (Fig. 5a - 5c)
Important: Disconnect the power plug before you adjust the tilt angle.
GB
The cutting blade can be tilted to make the work as easy as possible.
Pull the safety lever towards the rear (Fig. 5a/Item 12). Then grasp the
adjustment lever (Fig. 5b/Item E). Actuate the locking lever (Fig. 5b/
Item 13) and release it again when you have fi nished adjusting the tilt
angle. Make sure that the lever latches in place correctly. Then push
the safety lever towards the front (Fig. 5c/Item 12).
Important: When you have fi nished, make sure that the safety lever
and the locking lever are latched correctly.
Important: The gear unit can become hot during operation.
Anl_PE_EHH_9048_SPK7.indb 200 Anl_PE_EHH_9048_SPK7.indb 200
- 200 -
21.01.16 15:17 21.01.16 15:17