Auxiliary Handle; Depth Gauge; Selecting The Impact/Drill Mode - TOOLCRAFT T-SBM 710 W Notice D'emploi

Note: It is recommended to use the variable speed feature
for a short time only. Do not continuously operate the tool at
different speeds. It may damage the switch.
d) Auxiliary Handle
An auxiliary handle (7) is packed with the drill for ease of operation and
to help prevent loss of control. The handle can be rotated 360°and it can
also be mounted on the opposite side for left hand use.
• See figure E.
• Loosen the handle by turning the handle counterclockwise.
• Rotate the handle to the desired operating position
• Securely tighten by turning the handle clockwise.
e) Depth gauge
• See figure F.
• Change the position of the depth gauge (2), turn the grip of the handle
anti-clockwise until the depth gauge is loose enough to slide in the
hole.
• Set the depth, checking the depth with a steel ruler for most accurate
measurement and then turn the handle grip clockwise to tighten both
the depth gauge and the auxiliary handle in the required position.
f) Selecting the impact/drill mode
• See figure G.
The impact/drill switch (1) should be set according to the type of action
required. The tool has two settings:
Drill mode
Impact mode
26
For drilling into wood and metal.
Use standard drill bits.
For drilling into stone and masonry.
Use masonry drill bits.
Fig. E
Fig. F
Fig. G