Operation; Side Handle; Exchanging And Removing Drill Bits; Setting Depth Stop - TOOLCRAFT T-BH 800 W Notice D'emploi

7. Operation

Hammer drills require very little operator pressure. Excessive pressure on the tool can lead to unnecessary
overheating of the motor, and burning of the driven tool. It also may happen the drill bit deforms and cannot
be removed from the machine again.
a) Side handle
• See figure A.
• The side handle (4) can be rotated 360° around the drill head, enabling
safe and comfortable operation for both left and right-handed users.
- Loosen the handgrip by turning it anticlockwise.
- Rotate the handgrip to the desired position.
- Retighten the handgrip in the new position by turning it clockwise.
b) Exchanging and removing drill bits
Before exchanging bits, first remove the power plug form the
wall socket.
Inspect bits regularly during use. Blunt bits should be re-
sharpened or replaced.Lightly oil the bit shaft before inserting
it into the chuck.
• See figures A and B.
• SDS drills can be inserted by pushing the drill into the chuck until a
click can be heard. If needed rotate the SDS drill a little to ensure the
keyway in the bit fits the chuck well.
• To remove the SDS drill, slide the locking sleeve (5) to the rear and
remove the SDS drill while keeping the sleeve (5) in this position.
DO NOT slide the lock sleeve (5) to the rear when inserting
bits.
c) Setting depth stop
The depth stop ruler can be added to the side handle (4) by turning the
depth stop knob (7).
• Turn the depth stop knob (7) anticlockwise and inset the depth stop
ruler (6) through the hole on the side handle ring.
• Slide the ruler to the desired depth.
• Turn the depth stop knob (7) clockwise to tighten it.
Fig.B
5
25