When The Oven Is Working; Interrupting A Cooking Cycle; Altering Parameters; Cancelling A Cooking Cycle - Porter & Charles Combi Speed Mode D'emploi

USA

When the oven is working...

Interrupting a cooking cycle

You can stop the cooking process at any time by
pressing the Stop key once or by opening the
oven door.
In both cases:
Microwave emission
immediately.
The grill is de-activated but is still very hot.
Danger of burning!
The timer stops and the display shows the
remaining amount of operating time.
If you wish, at this time you can:
1. Turn or stir the food to ensure it will be
evenly cooked.
2. Change the process parameters.
3. Cancel the process by pressing the Stop
key.
To restart the process, close the door and press
the Start key

Altering parameters

The operating parameters (time, weight, power,
etc.) can only be altered when the cooking
process has been interrupted:
1. To alter the time, turn the rotating knob. The
new time defined is immediately valid.
2. To alter the weight/ power, press the
Weight/Power Selection key. The respective
light starts to flash. Alter the parameter by
pressing the "-"and "+"keys and confirm by
pressing the Power Selection key again.
23

Cancelling a cooking cycle

If you wish to cancel the cooking process, press
the Stop key for 3 seconds.
You will then hear a beep and the time will appear
on the display.
is stopped

End of a cooking cycle

At the end of the process you will hear three
beeps and the display will show the word "End".
The beeps are repeated every 30 seconds until
the door is opened or the Stop key is pressed.