Telcoma Automations TANGO 2 Notice D'instruction page 29

GB
TRANSMITTER TECHNICAL DATA
Battery power supply type GP 23A
Frequency
Stability
Radiated power
Operating temperature
Number of combinations
STANDARD PROGRAMMING
For correct, easy programming, it is essential that the following instruc-
tions are followed to the letter.
1. Preliminary operations
- Connect an antenna tuned to 433 MHz to the antenna terminal on the
receiver. Alternatively, diminishing the receiver specifications, a piece
of wire approx. 20 cm long may be connected
- Once the receiver has been connected to the control unit or the nec-
essary connections onto the terminal board have been completed,
switch on.
- As soon as the receiver is powered, it carries out an internal test,
shown by LED L2 coming on for 3 seconds.
2. Self-memorisation
- Upon pressing key P1 for an instant the relative led will blink 5 times.
- Within this period of time, transmit with the
radio control required for use.
- Fixed indicator lights lasting about 3 seconds
indicate that the code has been successfully
stored.
u.m.
V
MHz
KHz
? W
°C
1.048.576
12
433,920
+/-200
100
-20+60
29