• WALL MOUNTING
The Baby Unit can be placed on any sturdy, level
surface that will provide a good view of your baby. It
can also be wall mounted as follows: drill two holes
in the wall 32mm apart and fix the screws, using wall
plugs as necessary, leaving 6mm of each screw proud
of the wall. Next, with the AC Adaptor Jack connected,
slide the back of the Baby Unit down onto the screws
until it is secured to the wall. If necessary, remove the
Unit and adjust the screws in or out. Plug the adaptor
into the mains supply.
Twist the camera on the Baby Unit 180 degrees so the
camera is facing the floor when the base is mounted
on the wall. Once fixed, adjust the angle of the camera
to get the best view of your baby.
• CARING FOR YOUR MONITOR
Do not immerse any parts in liquid. Do not place in direct sunlight. Periodically examine product for signs of damage
to electrical parts and do not use until damage has been properly repaired.
• GUARANTEE
We guarantee your monitor against manufacturing defects for 2 years from the date of purchase on production of a
valid receipt. In the first instance of a manufacturing defect, we recommend that you return your monitor to its place
of purchase. If this does not satisfactorily resolve your problem, please visit our website for further advice. Full terms
and conditions can be also found on our website: www.tomy.eu
• TECHNICAL SPECIFICATIONS
- Batteries: Parent Unit - Rechargeable 1800mAh 2.4V Ni-MH battery (included).
- Power Supply: Mains adaptor rating: PRI: 100-240V~50/60Hz SEC: 5V 1000mA
- Operating Range: 250m in optimum 'open field' conditions.
- Operating Temperature: 0 - 50ºC.
- Frequencies: 2410~2470MHz.
• SAFETY INFORMATION
IMPORTANT! This monitor is restricted for indoor use only! The Tomy Baby Monitor is designed to help you monitor
your child and is not a substitute for adult supervision. This product is not a toy. Always keep electrically operated items
and their cables out of reach of babies and younger children. Under no circumstances should you place any part of
your monitor in or on a cot. Ensure all wiring is positioned safely so that children cannot become entangled and that no
trip hazard is created. Under no circumstances should the adaptors supplied with this monitor be used with any other
equipment. No other adaptors than those supplied should be used with your monitor. Be careful not to position the
adaptor where a child is likely to use it as a step. Putting weight on the adaptor while it is plugged in could damage the
unit or cause injury to your child. It is normal for chargers to become hot during use – take care when handling, allow heat
to disperse. DO NOT COVER. Disconnect charger if the product will not be used for several days. To prevent a shock hazard,
please disconnect from power supply before cleaning. The rechargeable battery within the Parent Unit should be recycled.
Do not dispose in normal waste. Do not attempt to dismantle any part of this product.
GB
32mm
Recommended screw size
Head width:
3.5 - 5.0mm
Shank width:
Less than 2.5mm
8
• BATTERY SAFETY
Charging, removal and replacement of battery pack should be carried out by an adult or under adult supervision.
Unplug the adaptor cord before replacing batteries. Use only the supplied battery pack or replacement battery pack
available by contacting Tomy Webcare. Please note that the guarantee becomes void if you use any other battery pack.
Clean all contact surfaces before installing the supplied battery pack. Take special care to ensure battery pack is inserted
correctly, observing (+) and (-) polarity marks on battery and product. Do not short circuit the contacts in the battery
compartment or the battery pack terminals. Remove the battery pack and unplug the pigtail of the battery pack when
storing the product for a long period of time or when the battery is dead. Dispose of exhausted battery packs safely, and
never dispose of batteries in a fire. Remove exhausted batteries from product. Do not mix old (used) and new batteries or
batteries of different types, e.g. rechargeable and alkaline or batteries of different makes/brands. Remove batteries from
product after use or if storing for long periods. Only use batteries of the same or equivalent type to those recommended.
Removal and recharging of rechargeable batteries should be carried out by an adult or under adult supervision. Do not
attempt to recharge non-rechargeable batteries.
Help the environment by disposing of your product and packaging responsibly. The wheelie bin symbols
indicate the product and batteries must not be disposed of in the domestic waste as they contain
substances which can be damaging to the environment and health. Please use designated collection
points or recycling facilities when disposing of the item or batteries.
• SIMPLE SOLUTION GUIDE
Should your monitor not be operating as expected, the information listed below should be adequate to resolve
your problems.
• FREQUENTLY ASKED QUESTIONS
Q. Does my Parent Unit need to be switched on or off whilst charging?
A. Either. Your Parent Unit will charge while switched ON or OFF. However, charging the unit when switched ON will
allow you to monitor your baby while charging.
Q. I have measured the temperature of my baby's room using another device and I get a different reading
than that on my monitor – why?
A. The temperature measuring device within your Tomy monitor is designed to give you an indication of the baby's
room temperature to within a small tolerance of + 1°C or - 1°C. Other devices will also have a similar tolerance.
Q. Can I use my monitor abroad?
A. You can use your monitor in the country it was purchased and anywhere in the EU. Although your monitor may
function correctly in other countries, its operating frequency may affect (or be affected by) other devices and could be
illegal. Tomy cannot accept any liability for use outside of the country in which you purchased your monitor or the EU.
Q. Will I hear the out-of-range and low battery alarms even when the volume on my monitor is set to zero (mute)?
A. Yes, alarms are unaffected by the volume controls.
Q. Can my monitor coexist with WI-FI and other 2.4GHz devices?
A. Your Tomy SR Monitor operates on a 2.4GHz frequency using Direct-Sequence Spread Spectrum (DSSS) technology
designed to coexist with WI-FI and similar wireless digital equipment. However, if multiple 2.4GHz devices are
operating in close proximity, some interference is inevitable. Should you experience reduced performance in either
your monitor or wireless devices, select another channel by pressing the Mode/Enter Key for 3 seconds, repeating as
necessary until you find a vacant channel.
GB
9