Evacuation By Recycling - ROBLIN Open 610 Mode D'emploi

EVACUATION BY RECYCLING

- Put the adjustment lever to the recycling position (down) and after installing the
active carbon filter (as described in the installation part of these instructions and in
accordance with the instructions attached to the recycling kit) the recycled air is
discharged through the louvers at the top of the hood facade.
- In this case the hood must be drawn fully down to completely free the facade louvers.
Replacement of the auvent (panel and facade assembled)
- Lift the auvent by its lower part and insert the two upper guide-slides in their respective
housings.
- Pivot the auvent downwards inserting the two lower guide-slides and tilt the auvent
until it closes.
- Reopen the auvent to make sure that it operates correctly and to check the presence
of the stop at full opening.
- Depending on the weight of the facade, the friction resistance of the auvent may be
adjusted from the inside by means of screws located at the front corners of the
appliance (fig. 10).
- If necessary, make a final alignment with the adjacent furniture by adjusting the
auvent screws supporting the facade.
106_10FA
10
9