For The Installer; Installation - ROBLIN Open 610 Mode D'emploi

- Each filter is supplied with installation instructions.
Panelwork
Use lukewarm water only, to which a non-aggressive cleaning liquid is added. Do
not use abrasive or aggressive products, or products containing alcohol.
Lighting
- Lighting is provided by two 40 W bulbs.
- To replace them, remove the grease filters
as described in the "Grease filter" section
(fig. 4) to gain access to the bulbs.
- Replace the defective bulb or bulbs with
identical models and replace the grease
filters.
In case of problems
If you request assistance from your After Sales Service, you should inform them of
the characteristics stated on the identification plate close to the motor in your hood
(model - type - serial number).

FOR THE INSTALLER

As the specialist, only you are competent to install and connect appliances.
This is why our guarantee is applicable exclusively and soley to appliances which
have been installed and connected by yourself, in accordance with the requirements
of ordinances in force. You will be responsible if this condition is not respected.

INSTALLATION

- The hood must always be fitted above the center of the cooker hob.
- The minimum distance between the top of the cooker hob and the bottom of the
hood shall be 650 mm.
- If your cooking appliance has a cover, check that it can be lifted without hindrance.
Assembly
- All accessories necessary for installation are supplied with the appliance.
- Use the template to position the support lug wall attachment holes and drill the holes
for the plugs (top edge of the hood aligned with the top of adjacent furniture).
- Attach the support lugs with appropiate screws.
Hood preparation
- Before starting wall mounting, the depth of the hood has to be adjusted to match the
depth of adjacent furniture.
6
4