Franke FFC 905-P Mode D'emploi Et Installation page 11

ELECTRICAL CONNECTION
• Connect the hood to the mains through a two-pole switch hav-
ing a contact gap of at least 3 mm.
• Remove the grease filters (see paragraph Maintenance) being
sure that the connector of the feeding cable is correctly inserted
in the socket placed on the side of the fan.
• Remove the chimney parts out of the packing leaving them one
inside the other.
• Extend slightly the two side parts of the chimney and place the
upper chimney on the chimney support 7.4.
• Fix the upper chimney with two screws 12c (2,9 x 9,5) sup-
plied
• Move the lower chimney downwards until the two side lips of
the chimney are completely inside their seats in the hood body.
• Remove the grease filters.
• Fix the chimney onto the hood body with two screws 12c (2,9
x 9,5) supplied, tighting them from inside the hood.
• Replace the grease filters.
EN
Chimney mounting
12c
12c
1
11
1