Franke FFC 905-P Mode D'emploi Et Installation page 10

Mounting the hood body
• If, according to installer, the empty space between the lower
part of the hood and the wall corner has to be filled, it is then
necessary to install the corner spacer 7.1 at the hood basis us-
ing two screws 12c (2,9 x 9,5) supplied.
• Fasten the two screws Vr placed at the hook areas of the hood.
• Hang the hood body on the specific screws 12b (4,2 x 12,7).
• Fasten definitively the support screws 12b (4,2 x 12,7).
• It is possible to level the hood body by adjusting the screws
Vr.
• To definitively fix the hood to the ceiling it is necessary to use
two remaining screws together with plug and washer. These
have to be placed from inside the hood.
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the
chimney using either a flexible or rigid pipe ø 150 or 120 mm,
the choice of which is left to the installer.
• To install a ø 120 mm air exhaust connection, insert the re-
ducer flange 9 on the hood body outlet.
• Fix the pipe in position using sufficient pipe clamps (not sup-
plied).
• Remove any activated charcoal filters.
RECIRCULATION VERSION AIR OUTLET
• Insert the extension pieces 14.1 laterally on the air outlet con-
nection piece 15.
Fix the connection piece with the extension pieces onto the
support 7.3 using the two screws 12e (2,9 x 9,5) provided.
• Insert the assembled unit inside the upper chimney support 7.4
using the 4 screws 12c (2,9 x 9,5) provided.
• Connect the hood with the air outlet connection piece using a
rigid or a flexible ø150 tube chosen by the installer. It will be
necessary to use narrow strips (not provided) for this connec-
tion.
• Make sure that the charcoal filter has been mounted inside the
hood.
EN
Connections
Vr
12b
ø 150 ø 120
12c
12c
1
10
0
9