Wilo RAIN3 Série Notice De Montage Et De Mise En Service page 35

Menu no. Parameter /
info
Over flow on
5.51 threshold
cistern
Tap water
5.52 on threshold
cistern
Rain water
5.53 on threshold
cistern
Calcination
5.54 protection
System
5.55 flushing
Flushing
5.56 duration
Max. run-
ning time
5.57
pump
Fault mes-
5.59 sage beha-
vior
Minimum
5.61
pressure
Delay dry
5.62 run protec-
tion
Dry run tap
5.63 water mode
duration
Dry run rain
5.64 water mode
duration
Maximum
5.70 pump cycles
per hour
Menu no. Parameter /
info
Alarm
6.00
Quit alarm
6.01
Alarm his-
6.02 tory 0 (new-
est item)
Alarm his-
6.03
tory 1
Alarm his-
6.04
tory 2
Alarm his-
6.05
tory 3
Installation and operating instructions Wilo-RAIN3
Description
Min. Max. Text
1 1000
1 1000
1 1000
0 7
7 31
1 9
0 360
Raise - Fall
0.7 1.0
1 180
1 180
1 180
1 60
Min. Max. Text
Off - Reset
0 2550
0 2550
0 2550
0 2550
Default Unit Ac- Description
cess
level
100 cm 3 The level threshold in cistern above over-
flow is reported. 5.22 < 5.51 < 5.24 <
5.29
<5.22> +10 cm 2 The level threshold below which to
switch to TWM (distance refer to 5.22)
5.22 < 5.52 < 5.53 < 5.51
<5.22> +10 cm 2 The level threshold above which to
switch to RWM (distance refer to 5.52)
5.22 < 5.52 < 5.53 < 5.51
7 d 2 To protected the valve against calcina-
tion it can be operate from time to time
as defined in this parameter
7 d 2 To clean up the break tank once in a
while it can be flushed with fresh water
after period defined here
3 min 2 Time which pump has to run totally in
TWM for the next pump operations. After
this time RWM are possible again.
0 min 2 Pump should no longer run than the
timespan defined here or else an alarm is
generated; 0s means unlimited running
time and no alarm message
Fall 2 zero- or one-signal in case of failure
1.0 bar 2 The pressure threshold below which a dry
running is detected
15 s 2 The delay to detect dry run. It avoids false
dry run detection by short impulse on the
input
20 s 2 Time in TWM to build up minimum pres-
sure
30 s 2 Time in RWM to build up minimum pres-
sure
35 1/h 2 Raise an alarm when pump is starting
more frequently than that threshold
Default Unit Ac- Description
cess
level
1 The submenu contains the ten most re-
cent error codes for alarms that have ap-
peared in the panel during operation
OFF 1 Use this item to reset all acknowledge-
able alarms
0 1 The most recent error code
0 1 The second most recent error code
0 1 The third most recent error code
0 1
en
35