SPM GT1 Manuel D'utilisation Et D'entretien page 72

Problem
The touch screen display
shows the message
"EEPROM ERROR"
The touch screen display
shows the message "NAND
ERROR"
The touch screen display
shows the message "BOARD
OVERTEMPERATURE"
The touch screen display
shows the message
"OVERCURRENT ERROR"
The touch screen display
shows the message
"PRODUCT DENSITY HIGH"
The touch screen display
shows the message
"MACHINE CODE ERROR"
Data di emissione: Dicembre, 2013
72/124
Possible cause
•
The main board memory is not working
•
The main board images memory is not
working
•
The main board temperature is too high
•
The current absorption is too high
•
The product consistency is too high and
the motor is not able to rotate
•
The unit software has not been set
properly
•
•
•
•
•
•
Revisione: 5
Solution
Replace the main board
Replace the main board
Check the root cause and solve
The product density or/and the
auger rotation speed are too
high, modify the functioning
parameters
Switch the unit off, wait for the
product temperature decrease
and before operate again modify
the product temperature
increasing it.
Replace the main board
Pag. :
by