Sanitas SMA 30 Mode D'emploi page 11

2. Preparation
2.1 Battery operation
Before using the appliance for the first time, charge the battery for at least
15 hours. To do this, connect the power unit to the mains supply. After
charging for the first time, charge time is approximately 7 hours. Turn off
the appliance when charging.
Connect the mains adapter cable to the jack on the appliance and plug the
adapter into the wall outlet. The LED indicator shows that the appliance is
charging.
After every charge, you can use the appliance for ~ 30 minutes.
Please note that you can best preserve the life of the rechargeable battery
by avoiding interruption to the charging cycle prematurely, and continuing
to operate the appliance until the battery is discharged.
Ensure that the mains adapter is unplugged from the mains power supply at
the end of the charging time.
2.2 Mains operation
If the battery is empty, the appliance can also be run using the plug-in po-
wer supply. To do this, let the appliance charge with the power unit for ap-
prox. 5 minutes; it will then be fully operational again. The appliance should
only be operated with the voltage indicated on the power unit.
2.3 What you should know about the appliance
This manicure and pedicure appliance is equipped with top-quality attach-
ments. It has a cuticle pusher and 7 attachments with a long-life sapphire
coating or polishing felt.
Together with the 2-level speed control and clockwise/anticlockwise ope-
ration, this ensures a professional pedicure and manicure that would other-
wise only be possible at a podiatrist.
3. Application
3.1 General
– This instrument is intended only for the treatment of hands (manicure)
and feet (pedicure).
– Select an attachment and push it onto the instrument spindle using a
slight pressure. To remove: pull the attachment and instrument apart in
the axial direction (straight).
11