Maintenance And Cleaning - Imetec R8001 Mode D'emploi

USER INSTRUCTIONS
• Insert the selected accessory (8) in the handle and it will be perfectly
attached when you hear a «click». (FIG A)
• To use the curling tongs at 90 degrees, hold the lower part (3) securely and
rotate the upper part (2) downwards (FIG B) until the two drawn triangles
are aligned. To return the curling tongs to the vertical position, rotate the
upper part (2) upwards (FIG B).
• Connect the cable (6) to the mains and place the appliance on a smooth
and heat resistant surface, where applicable, using the support system
integrated in the accessory (9).
• Turn the appliance on by setting the button (5) to position I and wait until
the accessory warms up. The temperature reached varies depending on
the accessory used.
• Use the heat-resistant glove (10) to protect the hand from temporary
contact with the accessory when wrapping the hair.
• Take a lock of hair, which is not too wide or voluminous, between the
fingers (about 2 cm), more defined curls are obtained with smaller locks
of hair.
• Keep the product with the tip facing downwards, start wrapping the lock of
hair around the top of the accessory, closest to the handle, and continue
to wrap the hair along the length of the tong.
• Keep in place for a few seconds, then release by unwinding the lock of hair
in the opposite direction.
• For an optimal effect, allow the curls to cool down.
• Repeat for every lock of hair.
• Once the hair is styled, switch the appliance off from the button (5) and
disconnect it from the socket.
• When the accessory (8) is completely cool, remove it by pressing the
release button (1) and pull the accessory in the opposite direction to the
handle (FIG C).
o n .

MAINTENANCE AND CLEANING

WARNING! Always disconnect the
appliance from the socket
cleaning or performing maintenance.
WARNING! Make sure all cleaned parts
are completely dry before reusing the
appliance.
• Switch the appliance off by setting the button (5) to O and remove
the plug (6) from the socket.
• Wait for the accessory (8) to cool.
• Clean the surface of the accessory (8) and the handle with a damp,
soft cloth.
14
EN
before