Manual Position Setting; Audio Preset Memory - Kenwood DPX503 Mode D'emploi

Function of DPX503

Manual position setting

Making fine adjustment of the value specified at
Preset position selection per speaker.
1
Enter Position setting mode
>
Select "SOUND"
"M-POSI".
For how to select Function Control item, refer to
<Function Control> (page 6).
2
Select the speaker you want to adjust
Item Setting overview
"Front Lch" Front Left speaker
"Front Rch" Front Right speaker
"Rear Lch" Rear Left speaker
"Rear Rch" Rear Right speaker
"Sub Lch" Subwoofer Left
"Sub Rch" Subwoofer Right
Turn the Control knob and push the center
when the desired item is displayed.
3
Adjust the speaker
Turn the Control knob.
Adjust between 0 and 5.58 feet.
4
Exit Position setting mode
Press the [FNC] button.
⁄
• When you select "USER" at <Preset position selection>
(page 20), the adjusted setting value will be recalled.
> >
"S-CTRL" "POSIT"
Function of DPX503

Audio Preset Memory

Registering the value setup by Sound Control. The
memory cannot be erased by the Reset button.
1
Setup Sound Control
Refer to the following operations to setup the
Sound Control.
- Cabin selection (page 19)
- DTA (Digital Time Alignment) setting (page 19)
- X'Over setting (page 20)
- Equalizer Control (page 20)
- Preset position selection (page 20)
- Manual position setting (page 21)
2
Enter Audio Preset Memory mode
>
Select "SOUND" "PRESET"
For how to select Function Control item, refer to
<Function Control> (page 6).
3
Put the Audio Preset in the memory
Press the Control knob.
"Memory?" is displayed.
4
Turn the Control knob to select "YES", and then
press the Control knob.
"Memory Completed" is displayed.
5
Exit Audio Preset mode
Press the [FNC] button.
⁄
• Register 1 pair of Audio Preset Memory. You cannot
register by the source.
• When you press the Reset, all the sources will be the
setting value which is registered.
>
"MEMO".
21
|
English