Temporary Operation / Voltage Setting - Toshiba RAS-M10YDCV-E Manuel Du Propriétaire

TEMPORARY OPERATION / VOLTAGE SETTING

TEMPORARY switch (COOL, AUTO)
When you can't use the remote controller temporarily due to missing, etc., temporary operation can be per-
formed on the switch panel.
• Setting the TEMPORARY switch to "AUTO" starts the automatic operation, to "COOL" starts the cooling
operation (LOW), respectively.
• Setting the TEMPORARY switch to "AUTO" or "COOL", the operation can't be performed from the remote
controller.
To stop the temporary operation, set the switch to "AUTO RESTART OFF".
Voltage setting
The most suitable voltage can be set up by combining the VOLTAGE SELECT 1 with 2 when adjusting the
voltage on the spot.
(Do not touch the switches at the installation time because an installation dealer will adjust them.)
TEMPORARY AUTO RESTART
COOL AUTO
VOLTAGE1
220V/230V
VOLTAGE2
220V 230V
OFF ON
240V
REMOCON
A B
Supply voltage
Voltage select 1/Voltage select 2
VOLTAGE1
220V/230V
220V
VOLTAGE2
VOLTAGE1
220V/230V
230V
VOLTAGE2
VOLTAGE1
220V/230V
VOLTAGE2
240V
4
240V
220V 230V
240V
220V 230V
240V
(Both are available.)
220V 230V
220V 230V