Publicité
Les langues disponibles
Les langues disponibles
5. FUNCTIONING / MANIPULATION
a) Installation / assembly:
- Unpack carefully the device of its packaging.
- Place it on a plane and heatproof surface.
- Never place the device near a wall or near a partition makes of combustible
materials even if it is very well isolated.
- A distance of minimum 10 cm with the partition or the wall is necessary.
b) First starting:
During the first use, heat the crepe machine during about 10 min to evacuate residual
smokes of manufacturing oil from the metallic parts. This may emit a slight smell for a
few moments. Once preheating is finished, set the thermostat on the wished tempera-
ture.
First cleaning
Clean the device before the first use. (See 6. Cleaning)
Connection of the device
- Check that the tension and the frequency of the electricity network suit to the
values indicated on the descriptive plate.
- Check that neither the cord nor the plug are damaged. If the cord is harmed, it
must be replaced by the producer, his after sale service or persons of similar
skills to avoid any risk.
- Make sure that every control knob is positioned on 0.
- Unwind completely the electric power cable and connect it in a plug connected
with the earth.
- The device is connected.
NB: in case of connection of the device in a plug without earth protection or directly on
the electricity network, confide its connection to a qualified person.
16
Publicité
