Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
3. Before first use
Remove the machine and the accessories
from the packaging. Check the machine for
transport damage and do not use the
machine in case of damages. Keep the
packing materials away from children, risk
of suffocation!
4. Contents of packing
1× Universal cordless mixer
1× Quick coupler
2× Flange spanners
1× Universal mixing paddle
1× Operating instructions
5. Intended use
The mixer has been designed for private use
only. It has not been designed for operation
in industry. With the supplied mixing paddle
the electric mixer is suitable for mixing
low-viscosity emulsions and viscous mate-
rials, for example: paints, lacquer, adhesives,
mortar, etc.
6. Operation
a. Firmly hold the electric mixer with both
hands.
b. Press safety button (7) and the ON/OFF
switch (8) with one hand. When the
device is operating there is no need to
hold down the safety switch.
Note: If the on / off switch is pressed lightly,
the mixer will run at the lowest speed. If the
on / off switch is pressed firmly, the mixer
will run at the highest speed.
c.
To switch off the device, release the
ON/OFF switch (8).
7. Gear selection
The mixer is equipped with an electronic
speed regulator and with a 2-gear drive. Use
the gear selection switch (4) to select one
of the two available gear speeds. The mixer
must have come to a complete standstill
before the gears are changed.
8. Inserting the agitator
Always remove the battery before inserting
or exchanging the agitator. The mixer is
equipped with a M 14 collet.
6
a. Screw the quick coupler (2) onto the
shaft (3) by turning counter clockwise.
b. Fix it by using the 2 supplied open-end
spanners. Turn the spanners to each
other so that the quick coupler is firmly
fixed in the tool carrier. To remove the
quick coupler, put the wrench back in
and pull them away from each other.
c.
Draw back the locking sleeve on the
quick coupler to insert the agitator (1).
Push forward the locking sleeve to lock
the agitator in place.
9. Cleaning and maintenance
WARNING: Remove the battery before car-
rying out any maintenance/cleaning of the
tool.
Cleaning
9.1
• Use only a moist cloth to clean the unit.
Do not use aggressive chemicals which
may dissolve plastic parts, or abrasives.
Always keep the ventilation slots clean
and free from obstructions.
• Keep safety devices, ventilation open-
ings and the motor housing as free as
possible from dirt and dust. Rub the
electric power tool with a clean cloth or
blow over it with low pressure com-
pressed air.
• We recommend that you clean your
electric power tool immediately after
each use.
• Clean the electric power tool regularly
with a damp cloth and somewhat soft
soap.
Maintenance
9.2
There are no inner parts of the tool which
need maintenance.
Publicité
Table des Matières
