Meec tools 019327 Mode D'emploi page 89

the evaporator system, but does not carry out the actual test. The
vehicle manufacturer is responsible to determine criteria for when the
test should be stopped automatically. Read the repair manual to see
which steps are necessary before this function is used.
FIG. 31
Vehicle Information
Select the item Vehicle Information and press the ENTER button to
show vehicle information, for example the chassis number (VIN),
calibration ID (CID), and calibration verification number (CVN).
FIG. 32
SETTINGS
Language
Press Language and select required language.
FIG. 33
Beeper
Press Beeper and select Off or On.
FIG. 34
Instructions (shown vid starting)
Press Instructions, Display at Startup and select Off or On.
FIG. 35
EN
89