Meec tools 019327 Mode D'emploi page 83

Erase fault codes
1. Select Erase Fault Codes and press the OK button:
FIG. 10
2. Press OK again to erase fault codes or press ESC to cancel.
FIG. 11
Read data stream
1. Select Read Datastream and press the OK button:
FIG. 12
2. Select Select Items and press the OK button.
FIG. 13
– Use the left and right buttons to browse.
– Use the up and down arrows to select the required
item.
– Press OK to confirm selection of data stream.
– Press ESC to read date stream.
Special functions
NOTE:
Special functions vary, depending on the model.
Press Special Functions. The following display image is shown:
FIG. 14
EN
83