Klarstein AROMATICA II Mode D'emploi page 36

EN
36
5. Release the lock on the cover (28) by pressing the small button.
6. Remove the cover (28).
7. Clean the grinding compartment (19) using the brush (21).
8. Mount the cover (28).
Descaling the appliance (fig. A - D)
• The appliance must be descaled after each 70 brewing cycles. If you leave the
mains plug in the wall socket, the appliance will keep track of the number of
brewing cycles.
• The indicator (D) will flash on the display to indicate that the appliance must
be descaled.
• If the appliance must be descaled, use a suitable descaling agent. Special
descaling agents are available from local specialist shops.
• Before descaling the appliance, remove the mains plug from the wall socket
and wait until the appliance has cooled down.
• Do not immerse the appliance in water or any other liquids.
• Make sure that the grinding function is not activated when descaling the
appliance.
To start the descaling process:
1. Open the cover (24).
2. If necessary, empty the water reservoir (14).
3. Remove the carbon filter holder (20) from the water reservoir (14).
4. Fill the water reservoir (14) with a suitable descaling agent.
5. Place the coffee pot (16) on the heating plate (18).
6. Insert the mains plug into the wall socket.
7. Switch on the appliance by pressing the on/off button (1).
8. Let the appliance run until 1/3 of the descaling agent is in the coffee pot (16).
9. Switch off the appliance by pressing the on/off button (1).
10. Let the descaling agent work for approximately 30 minutes.
11. Switch on the appliance by pressing the on/off button (1).
12. Let the appliance run until the remaining descaling agent is in the coffee pot
(16). The appliance stops automatically when the water reservoir (14) is empty.
Rinse the appliance twice according to the below procedure:
1. Fill the water reservoir (14) with clean water up to the maximum mark on the
water level indicator (15).
2. Place the empty coffee pot (16) on the heating plate (18).
3. Switch on the appliance by pressing the on/off button (1).
4. Let all water run through the appliance. The appliance stops automatically
when the water reservoir (14) is empty.