Publicité
Les langues disponibles
Les langues disponibles
Remote Control Settings
Code Range: TV
VCR
DVD
SAT/CBL
DVB-T
A. How to Enter Codes
1. Switch on the home appliance you wish to control and look up the first set of codes
of the home appliance in the code chart. For example: if you wish to insert the code
a PHILIPS TV set, the first set of code shall be 1492.
2. Press the "TV" button and the indicator light will light up.
3. Press and hold the "volume+" and "channel+" buttons at the same time until the
indicator is switched on (the indicator light will switch off and then on again).
4. Enter the 4-digit code. For example: the first set of codes for a PHILIPS TV set is
1492. Enter 1492.
Note:
I. The code entered is correct. The indicator light will flash twice before switching
off.
II. The code entered is incorrect. The indicator light will flash three times. Please
re-enter the code.
III. To exit the setting function, press the "Select Equipment Button". For example:
Press the TV button if the previous setting is TV.
5. After entering in the code, the indicator light will switch off.
6. Check if the other buttons operate correctly. If this is the case, the setting was
successful. If the buttons do not function correctly, please repeat steps 2 to 6 until
you have found the right code.
NOTE: If you install a device other than a TV, please follow the same procedure as
mentioned above under A but instead of pressing the "TV" button, press (depending on the
device you want to program) the "TV2" or "TV3" button, the "SAT1" or "SAT2" button, the
"VCR" button, the "DVD" button or the "DVB-1"button (depending on the device you want
to program) and search in the code list for the right code.
B. How to Search for Codes Automatically
1. Switch on the home appliance you wish to control. Place the remote control directly
at the home appliance, for example your TV.
2. Press and hold the "TV" button; the indicator light will light up.
3. Press and hold the "Volume+" and "Channel+" buttons at the same time until the
indicator light lights up. Then release both buttons (the indicator light will switch off
and then on again).
4. Press and hold the "POWER" button until the TV set is switched off. Release the
"POWER" button immediately.
5. Check if the other buttons operate correctly. If this is the case, the setting was
successful. If the buttons do not function correctly, please repeat steps 2 to 5 until
you have found the right code.
NOTE: If you install a device other than a TV, please follow the same procedure as
mentioned above under B but instead of pressing the "TV" button, press the "TV2" or
"TV3" button, "SAT1" or "SAT2" button, the "VCR" button, the "DVD" button or the
"DVB-1"button (depending on the device you want to program) and search in the code list
for the right code.
Maintenance:
Clean the product only with a dry cloth.
Do not use cleaning solvents or abrasives.
Warranty:
Any changes and/or modifications to the product will void the warranty. We cannot accept
any liability for damage caused by incorrect use of this product.
Disclaimer:
Designs and specifications are subject to change without prior notice. All logos, brands
and product names are trademarks or registered trademarks of their respective holders
and are hereby recognised as such.
Disposal:
•
This product is designated for separate collection at an appropriate collection
point. Do not dispose of this product with household waste.
•
For more information, contact the retailer or the local authority responsible for
waste management.
1000 — 1981
2000 — 2301
4000 — 4285
3000 — 3773
5000 — 5053
3
Publicité
