BEAL PERFORMER NPBR155/84H Notice D'emploi page 87

Troubleshooting
Troubleshooting the Tractor (Continued)
PROBLEM
Brake will not hold.
Tractor steers hard or
handles poorly.
Troubleshooting the Mower
PROBLEM
Mower will not raise.
Mower cut is uneven.
Mower cut is rough looking.
Engine stalls easily with
mower engaged.
Excessive mower vibration. Mower has other problem.
Engine runs and tractor
drives, but mower will not
drive.
LOOK FOR
Internal brake worn.
Steering linkage is loose.
Improper tire inflation.
Front wheel spindle bearings dry.
LOOK FOR
Lift linkage not properly
attached or damaged.
Mower not leveled properly.
Tractor tires not properly
inflated.
Engine speed too slow.
Ground speed too fast.
Mower has other problem.
Engine speed too slow.
Ground speed to fast.
Dirty or clogged air filter.
Cutting height set too low.
Discharge chute jamming.
Engine not up to operating
temperature.
Starting mower in tall grass. Start the mower in a cleared area.
Blade rotation control not
engaged.
Mower has other problem.
REMEDY
See authorized dealer.
See authorized dealer.
See Check the Tires section.
See authorized dealer.
REMEDY
See authorized dealer.
See authorized dealer.
See Check the Tires section.
Set to full throttle.
Slow down.
See authorized dealer.
Set to full throttle.
Slow down.
See Engine Manual.
Cut tall grass at maximum cutting height during first
pass.
Cut grass with discharge pointing toward previously
cut area.
Run engine for several minutes to warm-up.
See authorized dealer.
Engage the blade rotation control.
See authorized dealer.
en en en
27