Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Venting: Vent the hydraulic system before putting the log
splitter into operation.
Unscrew venting cap (7) by several turns so that air
may escape from the oil tank.
Leave the cap open during operation.
Close the venting cap before moving the log splitter, as
o herwise oil will leak at this point.
t
If the hydraulic system is not vented, the trapped air will
damage the seals and cause permanent damage to the
log splitter.
Mains connection
Compare the voltage given on the machine model plate
e.g. 400 V with the mains voltage and connect the ma-
chine to the relevant and properly earthed plug.
Only use connection cables with sufficient diameters.
Connect the machine via a 30 mA RCD (residual current
operated device).
Fuse protection
400 V 3~
10 A inert
Switching on / off
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
Prior to every use, check the function of the disconnec-
tion mechanism (by switching on and off).
7
1
Switching on
Press the green button.
Switching off
Press the red button.
Lock in case of power (zero-voltage ini-
tiator)
The equipment will switch off automatically if there is a power
cut. Repress the green button to switch it on again.
Log splitter with 400 V 3~
Make sure that the motor turns in the correct direction
(see arrow on the motor), because operation in the wrong
direction damages the oil pump.
Checking the direction of rotation:
Switch on motor; the splitting blade automatically moves to
the highest position.
If the splitting blade is already in its highest position: grip
both operating handles and push them down. The splitting
blade moves downwards.
If the splitting blade does not move after the motor has
started, switch off the motor and change the direction of
rotation.
Hydraulics
Never operate the machine in the event of any possible
danger from hydraulic fluid.
Ensure that the machine and working area are clean and
free of oil.
Danger of slippage or fire!
Check the hydraulic reservoir regularly to ensure that it
contains enough hydraulic oil (see "Care and mainte-
nance")
Capacity: 6.0 litres
W
o
r
k
i
n
g
W
o
r
k
i
n
g
SAFETY INSTRUCTIONS
additional
The log splitter may only be operated by a single person.
The machine may only be operated by persons over the
age of 18 years, and who have read and understood these
operating instructions.
Wear protective equipment (safety goggles/mask, gloves,
safety shoes) to protect yourself from possible injury.
Never try to split logs containing nails, wire or other similar
objects.
Already split wood and wood chips create a dangerous
working area. The operator may stumble, slip or fall. Al-
ways keep the working area neat and tidy.
19
You can change the
direction by placing a
screwdriver in the slot
provided in the plug
collar, and adjust the
correct
direction
moving to the left or
right applying slight
pressure.
w
i
t
h
t
h
e
l
o
g
s
p
l
i
t
w
i
t
h
t
h
e
l
o
g
s
p
l
i
by
t
e
r
t
t
e
r
Publicité
Chapitres
Table des Matières
