Tomy Digital Plus Notice D'emploi page 4

• SAFETY INFORMATION
The Tomy Baby Monitor is designed to help you monitor your child and is not a substitute for adult supervision.
This product is not a toy. Always keep electrically operated items and their cables out of reach of babies and younger
children. Under no circumstances should you place any part of your monitor in or on a cot.
Ensure all wiring is positioned safely so that children cannot become entangled and that no trip hazard is created.
Under no circumstances should the adaptors supplied with this monitor be used with any other equipment. No
other adaptors than those supplied should be used with your monitor. Be careful not to position the adaptor where
a child is likely to use it as a step. Putting weight on the adaptor while it is plugged in could damage the unit or
cause injury to your child. It is normal for chargers to become hot during use – take care when handling, allow
heat to disperse. DO NOT COVER. Disconnect charger if the product will not be used for several days. To prevent a
shock hazard, please disconnect from power supply before cleaning. The rechargeable battery within the Parent Unit
should be recycled. Do not dispose in normal waste. Do not attempt to dismantle any part of this product.
• BATTERY SAFETY
Removal and replacement of batteries should be carried out by an adult or under adult supervision. Take special
care to ensure batteries are inserted correctly, observing (+) and (-) polarity marks on battery and product. Do not
short circuit the contacts in the battery compartment or the battery terminals. Remove exhausted batteries from
product. Do not mix old (used) and new batteries or batteries of different types, e.g. rechargeable and alkaline or
batteries of different makes/brands. Dispose of exhausted batteries safely, and never dispose of batteries in a fire.
Remove batteries from product after use or if storing for long periods. Only use batteries of the same or equivalent
type to those recommended.
Removal and recharging of rechargeable batteries should be carried out by an adult or under adult supervision.
If you are using rechargeable batteries within the Baby Unit, they must be removed from the monitor before
recharging. Do not attempt to recharge non-rechargeable batteries.
Help the environment by disposing of your product and packaging responsibly. The wheelie
bin symbols indicate the product and batteries must not be disposed of in the domestic waste
as they contain substances which can be damaging to the environment and health. Please
use designated collection points or recycling facilities when disposing of the item or batteries.
• SIMPLE SOLUTION GUIDE
Should your monitor not be operating as expected, the information listed below should be adequate to resolve your
problems; alternatively a more comprehensive guide can be found on our website: www.tomy.eu
• FREQUENTLY ASKED QUESTIONS
Q. Does my Parent Unit need to be switched on or off whilst charging?
A. Either, your Parent Unit will charge whilst switched on or off, however charging the unit whilst switched on will
allow you to monitor your baby whilst charging.
Q. I have measured the temperature of my baby's room using another device and I get a different reading
than that of my monitor- why?
A. The temperature measuring device within your Tomy monitor is designed to give you an indication of the baby's room
temperature to within a small tolerance of + 1°C or - 1°C. Other devices will also have a similar tolerance.
Q. Can I use my monitor abroad?
A. You can use your monitor in the country it was purchased and anywhere in the EU. Although your monitor may
function correctly in other countries, its operating frequency may affect (or be affected by) other devices and could
be illegal. Tomy cannot accept any liability for use outside of the country in which you purchased your monitor or
the EU.
GB
6
• FAULT FINDING
PROBLEM POSSIBLE CAUSE
My Parent Unit will not The rechargeable battery (supplied)
switch ON. has not been installed correctly.
The rechargeable battery maybe below the
critical voltage to activate your monitor.
Mains power is not connected correctly.
My Baby Unit will not Mains power is not connected correctly.
switch ON.
Battery insertion and/or battery life
issues.
The Nightlight is active The Nightlight is being operated
but I cannot connect independently of the Baby Unit's
with the Parent Unit. monitoring function (which is an
intended feature).
There is a continuous Loss of contact alarm.
beeping noise.
There is a 2 x beep Low battery in Baby Unit.
alarm every minute.
There is a 3 x beep Low battery in Parent Unit.
alarm every minute.
I cannot hear anything Volume on Parent Unit is set too low.
through my Parent Unit.
And/or: Units are out of range.
It's only intermittent. Units are set to Sound Activated mode.
My Parent Unit makes a Units are not connecting.
continuous beeping noise.
My Parent Unit makes a One or both of the Units are running
random beep-beep every low on battery power.
minute or so.
High pitched noise. Units are too close together.
Volume too high.
Nightlight keeps The Nightlight is designed to switch
switching off. off automatically after 5 minutes to
conserve battery life.
Battery life after As with any rechargeable battery
charging is becoming it has a finite life and may need
shorter. replacing.
I cannot activate the It is not possible to activate the
Multicoloured Nightlight Multicoloured Nightlight feature from
feature from my Parent the Parent Unit.
Unit.
GB
SOLUTION
Insert the battery as instructed within this booklet or the
Quick Start Guide. Once installed place the Parent Unit on
charge and leave for several minutes before switching ON.
Place the Parent Unit on charge and leave for several
minutes before switching ON.
Check the power cable connections
(including wall socket).
Check the power cable connections
(including wall socket).
Check the batteries have adequate charge and are
correctly installed.
Switch the Nightlight OFF by pressing the button
then reactivate the Baby Unit's main function by
pressing and holding the button.
Ensure both units are adequately powered.
Bring both units closer together and repeat the
'Set-Up' instructions.
Replace batteries.
Or switch to mains (AC) using the adaptor supplied.
Recharge batteries.
Increase Parent Unit volume or place into the
Docking Station to activate High Definition Sound.
Move units closer.
Refer to Sound Activated Monitoring within this
instruction booklet.
Ensure both units are adequately powered and then
follow the 'Set-Up' guide within this booklet.
Identify the low battery condition and either
recharge/replace batteries or switch to mains power.
Move units apart.
Decrease volume.
For continual use please switch to mains power.
Please visit our website for replacement parts:
www.tomy.eu
Activate the Nightlight and then press and hold the
button from the Baby Unit.
7
PAGE
3
3
4
3
3
3
5
4
3
3
4
4
5
4