Chauvin Arnoux DTR 8510 Notice De Fonctionnement page 53

„ Each Measurement Record will record the Present Nameplate along with other associated parameters and will be available
when the data is downloaded.
„ The Ratio of the nameplate values must be between 1 and 32767.
„ The Nameplate needs to be enabled. If the Nameplate is not enabled, the Deviation % will not be reported after the measure-
ments. Subsequently, the stored values will not have Nameplate and Deviation % in the Measurement Record.
NOTE: The Main Screen will display the Present Nameplate only if it is Enabled. If it is not Enabled, it will display "---" for
Primary and Secondary.
To configure the settings for the Nameplate, perform the following:
1. Within the top level of Configure Instrument, press the  or  key until Setup Nameplate appears on the display, then press
ENTER.
2. The display will show Enable with Yes and No choices. Press the  key to select Yes (Enable Nameplate).
3. The display will now show the following screen:
4. Select List by pressing the  key. The list can then be scrolled from 0 to 9 Nameplate values by using the  or  key. Select
the desired Nameplate by pressing ENTER. The display will return to Setup Nameplate.
5. Press ENTER, then Yes () on Enable.
6. Select Edit by pressing the  key. The values in the Present Nameplate can be edited digit by digit by selecting each digit
with the  or  and then pressing the ENTER key. When the last digit on the Secondary is selected, the display returns to
Setup Nameplate.
Figure 4-9
Figure 4-10
Figure 4-11
Figure 4-12
Figure 4-13
53