Display Functions; Program Flow; Top Level Menu; Configure Instrument - Chauvin Arnoux DTR 8510 Notice De Fonctionnement

4.1. PROGRAM FLOW

In order to use the instrument efficiently, it is important to understand the program flow.
„ Pressing the  and  keys simultaneously allows going up one level (if there is a level) in the program flow. (Vertical naviga-
tion moving up a level).
„ Pressing the  or  key allows navigation within the level. (Horizontal navigation).
„ Pressing the ENTER key allows the selection and display of choices one level below (if there is a level) in the program flow.
(Vertical navigation moving down a level).

4.2. TOP LEVEL MENU

The instrument has a top level control as shown in Fig. 4-1.
The user can navigate around the ring by pressing the  or  key.
Once the instrument is turned on, it initializes and then displays the Main Screen:
„ Main Screen: Displays the Test Type, Test Mode, Filter [Fast (F), Normal (N) or Slow (S)], Storage Mode [Auto (A) or Manual
(M)] and the Present Nameplate values (if enabled).
„ Configure Instrument: Configures the instrument (see § 4.3).
„ Recall Data: Stored data can be selected and displayed (see § 4.4).
NOTE: The program flow is two or three levels deep at various points. The available choices for a level can be viewed by
pressing the  or  keys.
The ENTER key is used to select the following functions:
„ Enter configuration menu.
„ Enter Recall Data menu.
„ Initiate storage of test results, accept location parameters and store the Measurement Record.

4.3. CONFIGURE INSTRUMENT

With the display showing Configure Instrument, press the ENTER key. The configuration ring (see Figure 4-4) can be navigated
around using the  or  key.

4. DISPLAY FUNCTIONS

Main Screen
Configuration
Figure 4-1
Figure 4-2
Figure 4-3
50
Recall Data