Whirlpool W11296635A Instructions D'installation page 19

Refrigerator door closed completely? Close the door firmly.
■
If it does not close completely, see "The doors will not close
completely," earlier in this section.
Recently removed the doors? Make sure the water
■
dispenser wire/tube assembly has been properly
reconnected. See "Refrigerator Door(s) and Drawer."
Reverse osmosis water filtration system connected to your
■
cold water supply? This can decrease water pressure. See
"Water Supply Requirements."
Water is leaking from the dispenser system
NOTE: One or two drops of water after dispensing is normal.
Glass not being held under the dispenser long enough?
■
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
New installation? Flush the water system. See "Water
■
Dispenser."
Recently changed water filter? Flush the water system.
■
See "Water Dispenser."
■
Water on the floor near the base grille? Make sure the
■
water dispenser tube connections are fully tightened.
See "Refrigerator Door(s) and Drawer."
Water from the dispenser is warm
NOTE: Water from the dispenser is only chilled to 50°F (10°C).
New installation? Allow 24 hours after installation for the
■
water supply to cool completely.
Recently dispensed large amount of water? Allow 24 hours
■
for water supply to cool completely.
Water not been recently dispensed? The first glass of water
■
may not be cool. Discard the first glass of water.
Refrigerator connected to a cold water pipe? Make sure
■
the refrigerator is connected to a cold water pipe.
See "Water Supply Requirements."
19