EINHELL Professional TP-AG 1275 Mode D'emploi D'origine page 17

Surface sanding/grinding
Vibration emission value a
K uncertainty = 1.5 m/s
Warning!
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
Anl_TP_AG_1275_SPK7.indb 17 Anl_TP_AG_1275_SPK7.indb 17
= 4.2 m/s
2
h
2
- 17 -
GB
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Fitting the additional handle (Fig. 2)
•
The angle grinder must not be used without
the additional handle (3).
•
The additional handle can be secured in any
of 2 positions (A, B).
Tool side
Left (position A / as
shown)
Right (position B)
The additional handle on this model is fastened
to the machine housing by means of vibration-
absorbing elements which protect the user and
reduce fatigue during operation.
5.2 Fitting the guard (Fig. 3)
•
Remove the two flanges.
•
With the clamping lever (a) pressed as shown
in Fig. 3, push the guard (4) onto the equip-
ment.
•
Re-fit the two flanges to the spindle.
5.3 Adjusting the guard (Fig. 4)
•
Switch off the equipment. Pull out the power
plug.
•
Adjust the guard (4) to protect your hands
so that the material being ground is directed
away from your body.
•
The position of the guard (4) can be adjusted
to any specific working conditions. Press the
clamping lever (a), turn the guard (4) into the
required position and let go of the clamping
lever again.
•
Ensure that the guard (4) correctly covers the
gear wheel casing.
•
Ensure that the guard (4) is secure.
Take care that the safety device is secure.
Never use the angle grinder without the
guard.
Suitable for
Right-handed users
Left-handed users
19.06.13 16:09 19.06.13 16:09