Bosch PLS 300 Notice Originale page 21

OBJ_BUCH-1219-001.book Page 21 Wednesday, March 3, 2010 9:25 AM
Practical Advice
The following tips are for performing length or mitre cuts (90°/45°).
Problem
Cut runs out of centre
Wood surface unsatisfac-
tory after cut
For working instructions and practical advice on
the PLS 300 saw station, log onto:
www.bosch-do-it.com/pls300
Bosch Power Tools
Cause
Guide rail 4 not affixed
Saw blade too thin
Sawing feed too high (apply less
feed with power tool)
Angle adjustment of base plate to
saw chain incorrect
Saw blade does not run in guide
roller (see figure E)
Workpiece was sawn with the
visible side facing up
Saw blade worn
Sawing feed too high (apply less
feed with power tool)
Sawing was carried out with orbit-
al action switched on
For further questions, please refer to our cus-
tomer hotline:
Great Britain
Tel: +44 (0844) 736 0107
Australia, New Zealand
Phone: +61 (01300) 307 044
English | 21
Corrective Measure
Affix guide rail according to height
of workpiece; provide for firm
clamping of the workpiece
Use the provided saw blade
T144DP
Saw through workpiece applying
less and uniform feed
Do not apply pressure against the
side stops 5
Align base plate to saw chain and
retighten
Adjust guide roller in such a man-
ner that the saw blade is guided
(see operating instructions of the
jigsaw)
Saw workpiece with the visible
side facing down (see figure A3)
Insert new saw blade
Saw through workpiece applying
less and uniform feed
Do not apply pressure against the
side stops 5
Switch orbital action off
1 609 929 W68 | (3.3.10)