ZANKER KDV10000FA Notice D'utilisation page 22

Using the detergent
1
3
4
Setting and starting a programme
Setting mode
For some settings it is necessary that the appliance is
in setting mode.
The appliance is in setting mode when, after the activa-
tion, all the programme indicators come on.
If the control panel does not show this condition, press
and hold, at the same time, button
until the appliance is in setting mode.
Starting a programme without delay start
1. Open the water tap.
22
2
5
If the programme has a
prewash phase, put a
small quantity of deter-
gent on the inner part of
the appliance door.
and button
2. Press the on/off button to activate the appliance.
Make sure that the appliance is in setting mode.
3. Press the button of the programme you want to
set. The related programme indicator stays on
while all the other programme indicators go off.
4. Close the appliance door, the programme starts.
Starting a programme with delay start
1. Set the programme.
2. Press the delay start button again and again until
the indicator of the number of hours you want to
set comes on. You can set 3, 6 or 9 hours.
• The delay start indicator comes on.
3. Close the appliance door, the countdown starts.
• When the countdown is completed, the pro-
gramme starts.
Opening the door while the appliance operates
If you open the door, the appliance stops. When you
close the door, the appliance continues from the point
of interruption.
Cancelling the delay start while the countdown
operates
When you cancel the delay start, also the programme
is cancelled.
1. Press and hold, at the same time, button
button until all the programme indicators
come on.
2. Set the programme again.
Cancelling the programme
1. Press and hold, at the same time, button
button until all the programme indicators
come on.
Make sure that there is detergent in the detergent
dispenser before you start a new programme.
At the end of the programme
The indicator comes on.
1. Press the on/off button to deactivate the appliance.
2. Close the water tap.
and
and