ZANKER KDV10000FA Notice D'utilisation page 20

Adjusting the water softener
German
degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the water softener
1. Press the on/off button to activate the appliance.
Make sure that the appliance is in setting mode,
refer to "Setting and starting a programme".
2. Press and hold, at the same time, button
button until the indicators of buttons
and start to flash.
3. Press button
•
The indicators of buttons
• The indicator of button
flash.
• The current setting of the water softener is indi-
cated by intermittent acoustic signals and the
number of flashes of the indicator
– E.g. 5 acoustic signals and 5 flashes + pause
+ 5 acoustic signals and 5 flashes = level 5.
4. Press button
the setting. Each time you press the button you se-
lect the next level.
5. Deactivate the appliance to confirm the setting.
20
Water hardness
French mmol/l
degrees
(°fH)
84 - 90 8.4. - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
.
and go off.
continues to
.
again and again to change
Clarke
degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
Filling the salt container
Caution! Water and salt can come out from the
salt container when you fill it. Risk of corrosion.
To prevent it, after you fill the salt container, start a
programme.
and
,
1
Water softener
adjustment
Level
10
9
8
7
6
1)
5
4
3
2
2)
1
2