Technical Information; Environment Concerns - ZANKER KDV10000FA Notice D'utilisation

Stains and dry water drops on glasses and dishes
• The released quantity of rinse aid is not sufficient.
Adjust the rinse aid selector to a higher position.
• The quality of the detergent can be the cause.
Dishes are wet
• The programme is without a drying phase or with a
low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the combi detergent tablets can be
the cause. Try a different brand or activate the rinse
aid dispenser and use rinse aid together with the
combi detergent tablets.
Refer to 'HINTS AND TIPS' for other possible
causes.
How to activate the rinse aid dispenser
1. Press the on/off button to activate the appliance.
Make sure that the appliance is in setting mode,
refer to "Setting and starting a programme".

Technical information

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
Capacity
Power consumption
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot water supply to
decrease energy consumption.

Environment concerns

Recycle the materials with the symbol
packaging in applicable containers to recycle it.
Help protect the environment and human health and to
recycle waste of electrical and electronic appliances.
Do not dispose appliances marked with the symbol
26
2. Press and hold, at the same time, button
3. Press button
4. Press button
5. Press the on/off button to deactivate the appliance
6. Adjust the released quantity of rinse aid.
7. Fill the rinse aid dispenser.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Place settings
Left-on mode
Off-mode
. Put the with the household waste. Return the product to your
local recycling facility or contact your municipal office.
• Discard correctly the packaging material. Recycle
button until the indicators of buttons
and start to flash.
.
•
The indicators of buttons
off.
• The indicator of button
• The indicator
. The indicator
The rinse aid dispenser is activated.
and to confirm the setting.
2)
the materials with the symbol
and
continues to flash.
is off.
comes on.
446 / 818 - 898 / 550
220-240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
0.10 W
0.10 W
.
and
,
go
9