Atag NEOZ 3319471 Manuel D'installation page 9

BASIC FUNCTIONS
Room temperature regulation in Manual
mode
The operating mode of the zone associated
with the device is set to " " MANUAL.
Turn the knob to select the temperature value
indicated on the display using the movable
cursor close to the ring.
Press the knob to confirm.
The display shows the set temperature.
Room temperature adjustment in
Programmed mode
The operating mode of the zone associated
with the device is set to "
During operation in scheduled programming
mode, the set room temperature can be
changed temporarily. Turn the knob to select
the temperature value indicated using the
movable cursor close to the ring.
Press the knob to confirm.
The display shows the set temperature.
Turn the knob to set the time at which you
want the change to end.
Press the knob to confirm. The "
appears on the display.
The system interface will maintain the tem-
perature value until the set time, after which
the pre-set room temperature is restored.
Room temperature adjustment with SCI on.
If the heating (or cooling) hot water temperature does not match the desired value, it can be
increased or decreased via the "Heating Settings" (or Cooling settings). The correction bar
will appear on the display. Press the knob to confirm, or press the back button to return to
the previous screen without saving.
" PROGRAMMED.
" symbol
18:30 11/10/2020
10°
21°
,5
19
°
,0
SALOTTO
5 °C 30
18:30 11/10/2020
10°
21°
,5
19
°
,0
SALOTTO
5 °C 30
Fino alle 20:00
50%
1,5 bar
50%
1,5 bar
EN / 9