Publicité
Les langues disponibles
Les langues disponibles
Descriptions of display-functions
A
Channel number
B
Radio controlled clock
C
Clock / day / month display
D
Indoor / outdoor humidity
E
Trend / tendency display
F
Pressure reading
G
Wheather forecast symbols
H
Comfort display
I
Animated color graphs
J
Indoor / outdoor temperature
K
Heat index / dew point
BATTERY & ADAPTER INSTALLATION
Home Receiver Unit:
Main Power Source: Plug in the 6.0V adapter into
the adapter socket at the back for basic operation
and continuous backlight.
Backup Power: Lift off the battery cover , install
3 pieces of AAA backup batteries according to the
polarity indicated, close the battery cover.
Remote Sensor:
Loosen the screws
small screwdriver, insert 2 pieces of AAA batteries
according to the polarity indicated. Replace the cover
and tighten the screws
ALTITUDE SETTING
After inserting batteries or adapter , the main unit
will enter altitude (F) setting mode directly. Press
„" 3 or „" 4 to select pressure unit in hPa, mb
or inHg. Press "PRESSURE" 8 to conirm. Then
press „" 3 or „" 4 to enter your current altitude
in meter or feet. Press „PRESSURE" 8 to conirm
and exit the setting. This allows the unit to provide
a more accurate barometric pressure (F) & weather
forecast reading (G). (For more information, see
„WEATHER FORECAST & BAROMETRIC
PRESSURE" section)
313503_Manual_121120.indd 9
K
A
on the battery door
with a
.
J
B
C
SETTING UP THE WIRELESS THERMO-HYGRO-
METER:
• For the irst installation, always turn on the home
unit and then the remote sensor. Set Channel 1
for the irst remote sensor. Set channel 2 and
channel 3 for the 2nd and 3rd sensor.
• Press and hold „CHANNEL/SEARCH" 5 button
on main unit until a beep is sound to search for
remote sensor.
• Press the „Tx" button on the back of remote
sensor to transmit RF signal.
• When RF connection is established, the respecti-
ve temperature (J) & humidity (F) of the selected
channel will appear on the main unit.
RADIO-CONTROLLED CLOCK
The unit will start synchronizing the clock after
battery/adapter installation or reset. In normal
mode, press „ " at the back to enforce searching
of radio-controlled clock signal. The antenna icon (B)
will appear during synchronization, if the icon disap-
pear afterwards, radio time signal is not available at
the moment. Try other locations later. Place the unit
away from source of interference such as mobile
phones, appliances, TV etc.
Antenna icon (B) with full signal strength
appear on screen if the reception of radio-controlled
time is successful. The radio-controlled clock will
have a daily synchronization at 02:03 and 03:03
everyday. Each reception cycle is minimum
2.5 minutes and maximum 10 minutes.
9
I
D
E
will
English
20.12.12 09:49
H
G
F
Publicité
