Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
G) Programming the board
Step-by-step logic
1 2 3
4 5
Set the dip switches 1 and 2 to OFF
ON
ON
The state of the other dip switches has no effect
OFF
OFF
Automatic logic
1 2 3
4 5
Set the dip switch 1 to OFF
Set the dip switch 2 to ON
ON
ON
The state of the other dip switches has no effect
OFF
OFF
Single wing logic
1 2 3
4 5
Set the dip switch 3 to ON
ON
ON
The state of the other dip switches has no effect
OFF
OFF
Attention: before proceeding with the programming of the card, it is necessary that all the inputs are connected correctly (see chapters D1 and D2).
Radio-command codes self-learning: Press the P1 key once to insert a "Start" code; press the P1 push-button twice to insert a "Pedestrian Start"
code. Each time the push-button is pressed, the led DL1 flashes in acknowledgement. Subsequent pressures of the P1 key must be spaced by 1 sec.
minimum periods. When the led is lit with a fixed light transmit the code to be learn by means of the radio-command.
Erasing all stored codes: Press push-button P1 until the led DL1 goes off (about 10 seconds).
Setting the work time: Make sure the gate is completely closed. If not, position it manually. Press push-button P2 for about 3 seconds (the led DL1
will light with a fixed light) until the gate starts opening at a reduced speed. During this phase adjust the speed by means of the trimmer RV1 to obtain
the desired slow-down. After 3 seconds from the complete opening, push the P2 key again and wait for the led DL1 and the blinker to go on with a
fixed light. Then push the P2 key repeatedly (6 times) to program the following operations :
1)
motor M1 start
2)
motor M2 start (delayed)
3)
motor M1 slow-down start
4)
motor M2 slow-down start
5) motor M1 stop (after 5 seconds from the end of the run)
6) motor M2 stop (after 5 seconds from the end of the run) - end of programming
Setting the pause time: Press push-button P3 until the led DL1 lights. Let the desired pause time pass, then press push-button P3 again.
Condominium logic
1 2 3
4 5
Set the dip switch 1 to ON
ON
ON
The state of the other dip switches has no effect
OFF
OFF
1 2 3
4 5
Kickback / extra-push logic
Set the dip switch 4 to ON
ON
ON
The state of the other dip switches has no effect
OFF
OFF
2nd wing delay reset (zero delay)
1 2 3
4 5
Set the dip switch 5 to ON
ON
ON
The dip switch 3 must be positioned obligatorily in OFF
The state of the other dip switches has no effect
OFF
OFF
29
ENGLISH
Publicité
Chapitres
Table des Matières
