Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
Motor 1
Outputs for the opening/closure control of the motor which drives the first gate wing during the closing phase.
Motor 2
Outputs for the opening/closure control of the motor which drives the gate wing delayed during the closing phase. This wing is usually connected with
an electric lock.
Electric lock
Impulse control for the electric lock release.
4) Definitions of Power Supply Inputs/Outputs
AC IN
12Vac or 20Vac Input for the electronic board power supply.
12Vcc or 24Vcc OUT (It depends on the position of the Jumper JP2)
Power supply output for the photo-cells and/or any other accessory devices.
BATT IN
Input for a 12Vdc or 24Vdc backup battery connection, it depends on the power supply selected. In case of 24Vdc battery connection, It's
obligatory to remove the Jumper JP1. Attention: The electronic card isn't able to charge a 24Vdc battery, so it'll be necessary to connect a
suitable external battery-charger.
5) Definitions of Accessory Inputs/Outputs
Aerial
Input for the connection of a radio receiving aerial. This input can only be used if a radio receiver card is connected to the unit.
2nd radio channel
Auxiliary control output. To be used only if a two-channel radio receiver card is connected to the unit.
6) Definitions of Optical Signals
DL1 – Programming led (red)
It is lit (together with the blinker) in the programming phase and during the gate's motion.
DL2 – Mains power led (green)
It is lit when the 12Vac or 20Vac voltage is present to the AC IN input.
DL3 – Pedestrian start led (green)
It is lit when the pedestrian start control is operated.
DL4 – Start led (green)
It is lit when the start control is operated.
DL5 – Stop led (red)
It signals the gate's block state. The led goes off when the stop control is operated (emergency).
DL6 – Photo-cell led (yellow)
It signals the optical barrier's state. The led goes off when the photo-cell is covered by persons or vehicles
DL7 – Photostop led (yellow)
It signals the optical barrier's state. The led goes off when the photo-cell is covered by persons or vehicles
20

Publicité

Chapitres

Table des Matières
loading

Table des Matières