Krups 3MIX5500 Mode D'emploi page 9

Thank you for choosing a product from the KRUPS range, exclusively designed for preparing
food and for domestic use inside the home.
The safety instructions are part of the unit. Please read them carefully before using your new
appliance. Keep them in a place where you can find and keep them for future reference.
A Whisk
A1 Accessory ejection button / Blender
shaft and mini-chopper function
A2 Speed control
A3 Turbo button
B Multi-strand whisks for light preparations
C Mixers for heavy dough
D Alignment pin
E Stainless steel blender shaft (depending
„ „
Before first use, remove the accessories from their packaging and clean them in hot water.
„ „
Dry thoroughly.
Connect the appliance:
„ „
Your appliance has 5 speeds and a turbo button. Always mix or knead in position "1" before
switching to a higher speed - fig. 4.
„ „
For kneading heavy doughs we recommend that you only use position "5" - fig. 5.
„ „
You can also increase the speed by pressing the TURBO button (A3).
„ „
However we recommend that you use it only for a brief period of time (a maximum of 30
sec. for a heavy dough).
„ „
Before removing the accessories, please switch off the appliance (this will avoid splashing).
Set the speed selector (A2) to position "0" - fig. 7.
Mixer function with beaters B or kneaders C:
„ „
Depending on the amount to be prepared, place the ingredients in a suitable container
(preferably a shallow bowl or cup).
„ „
Set the speed selector (A2) to position "0" - fig. 1.
„ „
Insert the stems of the whisks (B) or mixers (C) in the holes provided and lock them.
„ „
Immerse the accessories into the mixture, before switching on the unit - this will avoid
splashing.
TIPS & TRICKS
Whisks and mixers have a specific design. The mixer or whisk with the alignment (D) must
be placed in the biggest hole – fig. 2 and fig. 3.
Blender function E (depending on model)
„ „
Check that the appliance is unplugged, that the speed control (A2) is set to "0" and that the
beaters or kneaders have been removed from the appliance.
DESCRIPTION
SET UP
USING YOUR APPLIANCE
on model)
F Measuring bowl (depending on model)
G Rear panel
H Mini-chopper (depending on model)
H1 Bowl
H2 Blade unit
H3 Lid centre
H4 Lid
9